Help Center1. Fill out the test information in the report page.
a. Scroll to the bottom of the page. There will be a drop-down labeled Tests.
Note: There will be multiple drop-downs if you have created multiple placements.
b. Select the Tests drop-down, and the Tests section will appear.
c. Verify that the proctor has been entered correctly.
d. Go to the Reading section, verify that the Test Depth is correct, and fill out the following: Dry Density, % Moisture, Density Count (Ct), and Moisture Ct.
e. At this point, the % Compaction (on the right) and Average (on the bottom) will populate with the results of your test.
f. Enter any remarks that you might have about your tests into the Remarks section.
g. Repeat steps b–f until all the test information has been populated.
h. Attach any files, images, or videos that are required for your report using the media buttons.
2. Submit your report by clicking the Close Lot button in the bottom right of the Lot Info section at the top.
Note: If there are any errors with your report, a pop-up will appear when you attempt to close the report that will log the issues with the report. There are two ways to resolve this:
i. Using the information provided, go through and either fix or enter the data required.
ii. There will be two or more override text boxes that appear. In the override text boxes, fill out your reasons for submitting your report with errors, and then close your report as shown in Step 2.